The Amp/Tyco/TE Connectivity Positive Lock Mark I connectors were used on the helm circuit breakers and helm switches for model years 2000 thru 2010. [Note: The model years 2000-2010 are just a placeholder until other boat owners can confirm the dates.]
These connectors will not disconnect by just pulling on the wire. You have to pull on the connector housing in order to get the connector to release from the terminal tab.
Cobalt used the black connector housing, but it is also available in the color “natural” as shown in the pictures below.
The above pdf is 3 pages trimmed from a 13 page pdf, and only show the Mark I connectors. The deleted pages show the Mark II and Mark III connectors which were not used by Cobalt.
Amp Positive Lock Mark I Connector
-
Titaniumboy
- Rear Admiral
- Posts: 582
- Joined: Sun Jul 19, 2020 12:55 am
- Location: California
- Contact:
Amp Positive Lock Mark I Connector
You do not have the required permissions to view the files attached to this post.
2007 Cobalt 240 with Merc 496 MAG Bravo 3
1977 18’ Beachcraft with Ford 302 V8 OMC 190
Whiskey Slough Marina
Holt, CA
1977 18’ Beachcraft with Ford 302 V8 OMC 190
Whiskey Slough Marina
Holt, CA
Who is online
Users browsing this forum: No registered users and 0 guests