Page 2 of 2
Re: Troubleshooting hydraulic swim platform
Posted: Tue Jul 09, 2019 7:35 am
by cmattj
Glad you got it done. Time to show off that cool platform with some water pics!
Re: Troubleshooting hydraulic swim platform
Posted: Thu Jul 11, 2019 3:36 pm
by 2ridgebacks
Good to hear!
Re: Troubleshooting hydraulic swim platform
Posted: Mon Aug 26, 2019 4:06 am
by powerguy
Another hydraulic trim platform troubleshooting question. Platform works intermittently. Push switch and beeper comes on and can hear what sounds like an electrical noise but no movement. Sometimes can make it finally work with repeated tries and sometimes need to drive it and stop again and it will then work. Any thoughts? Thanks in advance.
Re: Troubleshooting hydraulic swim platform
Posted: Sun Sep 08, 2019 9:08 am
by Ytmsn
powerguy wrote: ↑Mon Aug 26, 2019 4:06 am
Another hydraulic trim platform troubleshooting question. Platform works intermittently. Push switch and beeper comes on and can hear what sounds like an electrical noise but no movement. Sometimes can make it finally work with repeated tries and sometimes need to drive it and stop again and it will then work. Any thoughts? Thanks in advance.
Sounds like a power issue. Pull the connections apart and plug them back in. Clean them or add a touch of dialectic grease. There may be a bit of corrosion somewhere causing your intermittent problem. And let us know what you find out.
Re: Troubleshooting hydraulic swim platform
Posted: Tue Sep 10, 2019 6:05 pm
by powerguy
Did not end up buying that boat. To much neglect and cost to bring back condition.
Re: Troubleshooting hydraulic swim platform
Posted: Mon Jun 14, 2021 8:19 pm
by RanPil
Good day folks,
I bought a 2012 a25 with 175 hours last weekend. I’m trying to work out a few bugs. First and most important the hydraulic swim platform won’t go up or down. Pump sounds like it’s pumping, alarm comes on but no movement. The only time it moves is when we arch the solenoids but doesn’t go flush to the swim platform. Even if we can bring it flush for now would be great. Any advice?
Re: Troubleshooting hydraulic swim platform
Posted: Sun Sep 10, 2023 3:18 pm
by pchoate1
Hello, we just bought a 2010 A25 with the hydraulic swim platform. Whenever I am at idle or neutral, I get an alarm at the helm about every 45 seconds. At first I thought maybe it was oil pressure or water temperature But I have ruled both of them out. When adjusting the swim platform cams I noticed there was a sensor mounted in the platform and I am wondering if the sensor has gone bad and is where my alarm is coming from. Has anyone had this issue and been able to diagnose that sensor. Dealer says that sensor is no longer available and I would have to find an aftermarket sensor that would fit.
Re: Troubleshooting hydraulic swim platform
Posted: Sun Sep 10, 2023 4:41 pm
by AsLan7
pchoate1 wrote: ↑Sun Sep 10, 2023 3:18 pm
Hello, we just bought a 2010 A25 with the hydraulic swim platform. Whenever I am at idle or neutral, I get an alarm at the helm about every 45 seconds. At first I thought maybe it was oil pressure or water temperature But I have ruled both of them out. When adjusting the swim platform cams I noticed there was a sensor mounted in the platform and I am wondering if the sensor has gone bad and is where my alarm is coming from. Has anyone had this issue and been able to diagnose that sensor. Dealer says that sensor is no longer available and I would have to find an aftermarket sensor that would fit.
.
So glad you found us Pch1...
Not sure about your sensor but hopefully others will chime in shortly. You could start another topic on this subject.
Any pics of your A29?
And welcome aboard mate.
.