Amp Positive Lock Mark I Connector
Posted: Thu Aug 11, 2022 1:49 am
The Amp/Tyco/TE Connectivity Positive Lock Mark I connectors were used on the helm circuit breakers and helm switches for model years 2000 thru 2010. [Note: The model years 2000-2010 are just a placeholder until other boat owners can confirm the dates.]
These connectors will not disconnect by just pulling on the wire. You have to pull on the connector housing in order to get the connector to release from the terminal tab.
Cobalt used the black connector housing, but it is also available in the color “natural” as shown in the pictures below.
The above pdf is 3 pages trimmed from a 13 page pdf, and only show the Mark I connectors. The deleted pages show the Mark II and Mark III connectors which were not used by Cobalt.
These connectors will not disconnect by just pulling on the wire. You have to pull on the connector housing in order to get the connector to release from the terminal tab.
Cobalt used the black connector housing, but it is also available in the color “natural” as shown in the pictures below.
The above pdf is 3 pages trimmed from a 13 page pdf, and only show the Mark I connectors. The deleted pages show the Mark II and Mark III connectors which were not used by Cobalt.